I made an Ikea enclosure for the Prusa MK3S+ & MMU3. The instructions for making the enclosure are shown on the printables page. Here is my memo for making it ……..
- I made a mistake in the position of the pillars. I thought the pattern around the printed parts of the pillar was a pattern to prevent peeling during printing, but it was a pattern for positioning. ( This means that the pillar had to be placed inward from the edge of the table).
- The screws to fix the pillar to the IKEA table on the floor were not properly fastened (they rotate). I may change the printed parts by making a second screw hole from the top, or by screwing from the side.
- I found the 3D data and the use of supports very informative.
The original data is for MMU2, and it looks like some modifications are needed for MMU3. Next, I will modify the filament buffer.
